• The Cube Only, for 3DR's Solo Platform
  • The Cube Only, for 3DR's Solo Platform

The Cube Only, for 3DR's Solo Platform, this is Experimental

Solo Cube
  • Model: HX6001
$168.00
*
*
*


THIS ITEM IS OUT OF STOCK, But on the way and Should arrive 1-12-2018  

Do to Overwhelming Demand, these will not actually be a green cube, but a black cube with a marking noting it's purpose. In order to meet the community needs, instead of waiting on a long production, the factory is making the internal changes needed to meet Solo's requirements.  

INSIDE THE CUBE

An STM32F427 Rev 3 Flight management unit. (where the flight controller lives.)

An STM32F100 I/O processor with pass through capabilities for failsafe. (deals with the Receiver and outputs )

3 IMU's1 Fixed 10 Axis IMU on the main Main board. (MPU9250 3 axis Accell, 3 axis gyro, and 3 axis mag, MS5611 Barometer)

2 Vibration Isolated and heat controlled 9DOF IMU's and an isolated Baro.

(MPU9250 3 axis Accell, 3 axis gyro, and 3 axis mag, LSM303D 3 axis Accelerometer, 3Axis Magnatometer, L3GD20 3 Axis GyroMS5611 Barometer

In case you missed it.... 3 IMU's STANDARD.all connections are via an 80 pin DF17 connector on the base. the following connections are included.2x CAN (pins reserved for a 3rd Can bus on next years model)

2x I2C5x Serial (1 reserved for debug)

2x SWD debug ports2x Power input V+I1x Analogue input (one of the power inputs can be used as Analogue if you need)Buzzer raw pwmSafety switch8 x I/O connected PWM out

(Solder option for 3.3 or 5v levels, default 3.3)

(opto drive capable 10mA each)6 x Aux FMU connected I/O

(PWM or alternate function)Servo rail I/O backup power (10.5v Max)2x 5.4v power in pins.

All other pins are reserved DNC.


There is a Lot of Information on how to install The most Current Version Of Matt's Install is HERE

https://www.youtube.com/watch?v=tetHQk0Y0lU




The Open Solo Link is Here
https://github.com/OpenSolo/documentation/…/master/README.md


Although it's highly suggested to READ ALL ABOVE, This Skips right to the Green Cube Install:
https://github.com/OpenSolo/documentation/blob/master/green_cube_install.md



For Necessary information Check back to the Face Book groups Located here: 

Solo Owners Group.


Solo Beta Test


Solo Mod Club